Package Contents

Dish Antenna

Antenna Feed

Mounting Bracket

Protective Shroud

Lower Pole Bracket

Upper Pole Bracket

Support Arm

Brace

Pole Clamps (Qty. 2)

Stabilizer Brackets (Qty. 2)

Screws (Qty. 4)

Hex Head Bolts (Qty. 5)

Lock Washers (Qty. 5)

Flat Washers (Qty. 5)

M10x100 Bolts (Qty. 2)

Serrated Flange Nuts (Qty. 2)

M8x150 Carriage Bolts (Qty. 4)

Installation Requirements

• 5 GHz Rocket® radio (sold separately)
• Phillips screwdriver
• 13 mm wrench
• Wrench or channel lock pliers with 63.5 mm (2.5") capacity
• Shielded Category 5 (or above) cabling should be used for all wired Ethernet connections and should be grounded through the AC ground of the PoE.

  We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. For more details, visit ui.com/toughcable

Hardware Installation

1. 

	Note: Ensure that the antenna feed slot of the Mounting Bracket lines up with the antenna feed slot of the Dish Reflector, as shown:



2. 

	IMPORTANT: The Dish Reflector and Antenna Feed are keyed so the Antenna Feed can only be installed in a single orientation.

	Note: Ensure that the straight edge of the Antenna Feed end (as shown) and arrow on the Antenna Feed cap are pointing straight up.

3. 

	Note: Hand-tighten until the knob touches the surface of the Mounting Bracket. Then use a wrench or channel lock pliers to tighten the knob an additional ¼ turn. Do NOT over-tighten the knob.

	Note: Ensure that the Antenna Feed is securely attached by the knob.

	IMPORTANT: Do not handle the antenna by the Antenna Feed once the feed is connected.

4. 

5. 

6. 

7. 



	Note: Ensure that each Lock Washer is always installed between the Hex Head Bolt and Flat Washer.

8. 

	Note: Ensure that the degree settings are facing outward and are the same on both arms of the Upper Pole Bracket.

9. 

10. 

11. 

12. 

13. 

14. 

15. 

16. 

17. 

	IMPORTANT: Before adjusting the tilt angle, ensure that the six Hex Head Bolts are loose enough to allow movement. If you cannot spin the washers freely by hand, then loosen the Hex Head Bolts until you can.

18. 

19. 

Specifications